Compressor Installation Safety Precautions

 

First, the installation

Installation of the compressor should follow local laws and regulations, and strictly comply with the following provisions:

1 , the compressor should be used to load-bearing capacity greater than the unit weight lifting equipment for lifting, lifting speed, acceleration should be limited to the extent permitted by .

2, try to install the compressor in a cool, clean, well-ventilated place to ensure clean air and water content of the smallest compressor suction .

3, the compressor intake air must not contain flammable gases and corrosive gases, to avoid any possible or internal corrosion.

4 , air-cooled machine should have the best fan or air duct to export outdoor hot , hot air circulation to avoid air inlet .

5 , compressors sewage , waste emissions should comply with the local environmental protection department.

6 , the machine uses a three-phase AC power supply 380V, 50Hz, power line guide compressor must match its power and install air switch , fuse and other safety devices , to ensure reliable and safe electrical equipment must be grounded .

 

Second, commissioning and operation ( special attention )

1, the new machine debugging , you must specify or approved by the Company's commissioning personnel ;

2 , before starting to be recognized in the unit unattended and check for legacy items and tools , shut the door on the unit ; should turn around crew prior notice attention to safety ;

3, commissioning, operation direction of the compressor strict inspection , when found to be reversed immediately shut down, turn off the power , the three-phase line swap any two re- boot, otherwise it will damage the compressor ( power plant overhaul every note ! )

4 , the compressor does not work at temperatures above nameplate exhaust pressure , otherwise it will cause the motor to overload and burn ;

5 , when the compressor is in the remote control , the machine may start at any time , should be listed reminder ;

6 , when the compressor is faulty or unsafe exist, do not force the boot , you should cut off the power and make a significant mark .

 

Third, the maintenance service

Compressor maintenance and repair must be under the guidance of qualified personnel

1 , compressed air and electrical appliances are dangerous , repair or maintenance should be sure that the power has been cut off , and hang " overhaul " or "No floodgates " and other warning signs at the power supply to prevent harm to others switch on power transmission ;

2, must wait for the entire compressor cooling and compressed air safety shutdown maintenance release , and maintenance personnel as possible to avoid any compressor system vents , close the corresponding isolation gates ;

3, the cleaning crew parts, safety should be non-corrosive solvent , prohibited the use of flammable and volatile cleaning agent ;

4, after the compressor run time, safety valves , etc. should be checked on a regular basis to protect the system , to ensure that their sensitive and reliable , general inspection once a year ;

5 , parts of the compressor plant to provide must be positive , it must be our designated screw oil screw compressors for oil and non- oil mix two brands , otherwise it will cause the system to set the focus cause a major accident .